For all those who kept bugging me on IRC about “what’s your status” and “when will you release it”, etc.. I’d like to give you a quick status update on my project :
First, this is NOT and I repeat, it’s NOT a port of PSGroove for the N900.. I started my project long before PSGroove was released, and my code has absolutely nothing to do with theirs and we don’t share any code in common. It is NOT a port, it’s a different implementation of the same exploit!
Secondly, it’s going pretty well so far, I finished writing it, all the code is there, and I’m testing it but I’m still getting some issues, for some reason the PS3 isn’t accepting the JIG, I hope I can get this fixed soon, so please, everyone just be patient, I will release it when it’s ready! But the good news is that it’s doable apparently!
For those who read my previous post, here’s an update :
- The kernel OOPS I was getting on linux was because my ‘hub’ was a high speed one, and when a device gets connected, the reply to GetPortStatus ommitted the ‘high speed’ flag in the response.. apparently, a high speed hub can only have high speed devices plugged into it, you can’t plug full speed or low speed devices in a hub, otherwise, your linux kernel crashes! It’s a use case the kernel developers didn’t think of (or didn’t find a way to test it). I will also soon release the code to reproduce that oops so people can look into it.
- I was able to get and set the address on the controller, but I had to add two new functions to the usb-gadget API. This means that you will eventually need to flash your device’s kernel to get advantage of the new functions.
- I figured out how to send a NAK in response to a IN interrupt.. you simply don’t queue anything, the controller apparently takes care of that automatically for you! and I had to read almost all of the controller’s code to figure that one out!
By writing this exploit as a standard linux driver, this means that my module can be used on any other linux-enabled devices.. this means not only the N900, but also the 770, N800, N810, Android phones and future Meego devices. It might need a little porting for some devices though, but it should still work…
That’s it, I’ll keep you informed on how it goes. Hopefully, we’ll soon be able to run homebrew on our PS3 simply by plugging our N900 to it, what a wonderful device it is